Installing the SE Sport 400 hydrofoil is simple and painless! With just 2 household tools and about 15 minutes, you can have your watercraft outfitted with the most advanced hydrofoil on the market and experience that noticeable boost in performance.
Drill-Free Installation: The SE Sport 400 comes with all the hardware you need. (FourDisk-Grips , rubber washers, bolts, washers, adhesive strips and locknuts.) *Most installations will only require a 7/16″ open end, or socket wrench and Phillips screwdriver.
Conventional Drill Assembly: If you prefer to drill your cavitation plate, set the Sport 400 in the desired position, and mark the four inside holes with a center punch. Drill the four inside hole placements, using a 1/4″ drill bit. Install using the same hardware without the Disk-Grips™ and rubber washers (or optionally, choose to drill the rear two holes and use two Disk-Grips forward).